笼形聚偕胺肟树脂的研究HX／ACAO树脂吸附贵金属

氢卤酸、硝酸、硫酸、磷酸和硼酸处理的笼形聚偕胺肟树脂（ＨＸ／Ａ－ＣＡＯ）对Ａｇ＋和等贵金属离子的吸附能力按如下顺序：ＰｄＣｌ４２－：Ｈ３ＢＯ３／ＡＣＡＯ＞ＢＣＡＯ＞Ｈ３ＰＯ４／ＡＣＡＯ＞ＨＩ／ＡＣＡＯ＞Ｈ２ＳＯ４／ＡＣＡＯ＞ＨＣｌ／ＡＣＡＯ＞ＨＮＯ３／ＡＣＡＯ＞ＨＦ／ＡＣＡＯ．ＩｒＣｌ６２－：ＢＣＡＯ＞Ｈ３ＰＯ４／ＡＣＡＯ＞Ｈ３ＢＯ３／ＡＣＡＯ＞ＨＣｌ／ＡＣＡＯ＞ＨＦ／ＡＣＡＯ＞ＨＩ／ＡＣＡＯ＞Ｈ２ＳＯ４／ＡＣＡＯ≥ＨＮＯ３／ＡＣＡＯ．ＰｔＣｌ６２：ＢＣＡＯ＞Ｈ３ＢＯ３／ＡＣＡＯ＞Ｈ２ＳＯ４／ＡＣＡＯ＞ＨＮＯ３／ＡＣＡＯ＞ＨＣｌ／ＡＣＡＯ＞ＨＦ／ＡＣＡＯ＞Ｈ３ＰＯ４／ＡＣＡＯ＞ＨＩ／ＡＣＡＯ．Ａｇ＋：ＢＣＡＯ＞Ｈ３ＢＯ３／ＡＣＡＯ＞ＨＩ／ＡＣＡＯ＞Ｈ２ＳＯ４／ＡＣＡＯ＞ＨＦ／ＡＣＡＯ＞ＨＣｌ／ＡＣＡＯ＞Ｈ３ＰＯ４／ＡＣＡＯ＞ＨＮＯ３／ＡＣＡＯ．ＡｕＣｌ４－：ＢＣＡＯ＞Ｈ３ＢＯ３＞Ｈ３ＰＯ４／ＡＣＡＯ＞ＨＦ／ＡＣＡＯ＞ＨＣｌ／Ａ－ＣＡＯ＞Ｈ２ＳＯ４／ＡＣＡＯ＞ＨＩ／ＡＣＡＯ＞ＨＮＯ３／Ａ－ＣＡＯ．研究了Ｈ３ＢＯ３／ＡＣＡＯ树脂对Ａｇ＋和离子的吸附动力学，讨论了吸附机理．     

X射线荧光光谱法分析玻璃纤维中主、次量元素成分

采用粉末压片-波长色散X射线荧光光谱法分析了中碱及无碱玻璃纤维中硅、铝、钙、镁、铁、钛、钾、钠、砷、氟等10种主、次量元素成分含量。以6个标准样品并结合两个参考样品建立校准曲线，采用DeJongh模式方程有效校正玻璃基体中元素间的吸收增强效应和重叠效应。该方法测定10个元素的精密度和准确度均较好，其相对标准偏差在0．35％～2．86％之间，对实际样品的分析结果与化学法相吻合，可应用于玻璃纤维中多元素成分的快速分析。     

Mesoporous titanium dioxide as a novel solid-phase extraction material for flow injection micro-column preconcentration on-line coupled with ICP-OES determination of trace metals in environmental samples

Mesoporous titanium dioxide as a novel solid-phase extraction material for flow injection micro-column preconcentration on-line coupled with ICP-OES determination of trace metals (Co, Cd, Cr, Cu, Mn, Ni, V, Ce, Dy, Eu, La and Yb) in environmental samples was described. Possessing a high adsorption capacity towards the metal ions, mesoporous titanium dioxide has found to be of great potential as an adsorbent for the preconcentration of trace metal ions in samples with complicated matrix. The experimental parameters including pH, sample flow rate, volume, elution and interfering ions on the recovery of the target analytes were investigated, and the optimal experimental conditions were established. Under the optimized operating conditions, a preconcentration time of 90 s and elution time of 18 s with enrichment factor of 10 and sampling frequency of 20 h⁻¹ were obtained. The detection limits of this method for the target elements were between 0.03 and 0.36 μg L⁻¹, and the relative standard deviations (R.S.D.s) were found to be less than 6.0% (n =7, c =5 ng mL⁻¹). The proposed method was validated using a certified reference material, and has been successfully applied for the determination of the afore mentioned trace metals in natural water samples and coal fly ash with satisfactory results.     

Inductively coupled plasma atomic emission spectrometry — Optimization of the operating conditions in the determination of trace of elements in line-rich emission matrices

Radial viewing 40.68 MHz inductively coupled plasma atomic emission spectrometer was used in the determination of Y, Sc and rare earth elements in Eu₂O₃ or Lu₂O₃ as pure rare earth matrices. The Mg II 280.270 nm/Mg I 285.213 nm line intensity ratio was measured to evaluate the robustness of the operating conditions. The operating conditions were affected by varying the incident power and sheathing gas flow rate. The carrier gas flow rate remained a constant value. The relationship between the Mg II 280.270 nm/Mg I 285.213 nm ratio and the excitation temperature was obtained. A dependence of the magnesium ratio in the pure solvent and the corresponding values in the presence of the above matrices was established.     

The use of carbon nanofibers microcolumn preconcentration for inductively coupled plasma mass spectrometry determination of Mn,Co and Ni

Based on carbon nanofibers (CNFs) as a solid phase extraction adsorbent, a microcolumn preconcentration method coupled to inductively coupled plasma mass spectrometry (ICP–MS) was developed for the determination of trace elements (Mn, Co and Ni). The effect of various experimental parameters such as pH, sample flow rate and volume, elution solution and interfering ions on the retention of the studied ions have been investigated systematically. During all the steps of the experimental process, Mn, Co and Ni could be quantitatively sorbed on the microcolumn containing CNFs in the range of pH 6.0–9.0, and then eluted completely with 0.5 mol ml^− 1 HNO₃. A preconcentration factor of 150-fold was obtained. The detection limits for Mn, Co and Ni were 40, 0.4 and 8.0 pg ml^− 1, respectively, with relative standard deviations less than 6.0%. In order to validate the proposed method, two certified reference materials of human hair (GBW 07601) and mussel (GBW 08571), and water sample were analyzed with satisfactory results. The recoveries were between 95.0 and 114%.     

中国不同类型土壤中稀土元素的形态分布特征

采用中子活化分析地中国不同地带土壤中的稀土元素含量分布模型及其赋存形态进行了系统的研究。结果表明，黄棕壤，褐土，淋溶黑钙土及白浆土中稀土元素的分布均为轻稀土富集，Ｅｕ亏损型，砖红壤，红壤为轻稀土富集，Ｃｅ亏损型。     

无机胶体法制备Pt/C催化剂及其性能表征

采用无机胶体法制备用于质子交换膜燃料电池(PEMFC)的Pt/C催化剂。研究了影响PtO₂胶体生成和稳定性的因素(溶液的pH值、浓度和温度条件等)以及不同还原剂浓度对Pt/C催化剂性能的影响。透射电子显微镜测试结果表明，采用经优化的工艺条件所制备的Pt/C催化剂平均粒径为3 nm，且分散性好、粒度均匀。X-射线衍射分析表明，催化剂中Pt(111)晶面的相对含量较高，有利于加速氧还原反应。单体PEMFC的电压/电流密度曲线测试表明，所制备的Pt/C催化剂具有良好的电化学性能。     

12种道地中药中无机元素的含量测定

报道了用Ｘ射线荧光分析法测定的１２种道地中药，９８个不同产地样品中的Ｆｅ、Ｃｕ、Ｚｎ、Ｍｎ、Ｓｒ、Ｃａ、Ｋ含量。结果表明，不同种属，不同产地，不同品种中药元素量存在差异，不同加工方法影响中药中元素含量，同种中药中元素分布模式也不同。     

电感耦合等离子原子发射光谱法测定硅铁中五元素

报道了硅铁中锰、钙、铝、铬及铜五元素的电感耦合等离子原子发射光谱法(ICP-AES)同时测定方法.对仪器的工作条件和各元素分析谱线的选择进行了试验和优化.通过对多个硅铁标准样品的分析,证实了方法的可行性,所得测定结果与标准值一致.回收率试验所得结果在99.0%～105.0%之间.     

银菊珍珠胶囊中稀土元素的电感耦合等离子体质谱分析

建立了一种电感耦合等离子体质谱法测定银菊珍珠胶囊中稀土元素的方法。利用该方法分析了国家一级灌木枝叶标准物质（GBW 07603）和国际柑橘叶标准物质（NIST1572）中的稀土元素，结果与标准值一致。该方法已被用于分析银菊珍珠肢囊样品中的稀土元素。